Fastening Kits

Introduction

To connect terminal blocks (Screw Clamp and ADO System Terminal Blocks) fasteners are required, e.g. metal tube (post), screw and washer.

Place the metal tube into the top centre hole on each terminal block to be connected. The metal tube contacts the terminal block’s internal connector bar. The perforated bar is cut to length and placed flat along the centre opening of the series of terminal blocks. The screw is inserted into the perforated bar’s hole which is located directly above the blocks being connected. The screw goes through the threaded metal tube and is screwed into the terminal block’s internal connector bar. This completes the electrical connection to the perforated bar and connects the block.

11- Fastening Kits

Products

Do NOT follow this link or you will be banned from the site!